Built-In Units
Standard under-counter dishwashers, aligned and secured flush with cabinets.

Dishwashers
New dishwasher sitting in the garage? We remove the old one, connect water and drain lines correctly, level and secure the new unit, and test it before we leave.
Request service
Clean Installs
A dishwasher needs three things done right: a hot water supply with its own shut-off, a drain line with a high loop or air gap so dirty sink water cannot flow back in, and a secure, level fit so the door seals and nothing shifts. Miss one and you get slow leaks under the cabinet, standing water or a machine that walks out of its opening.
We disconnect and remove the old unit, check the supply valve and replace it if it is worn, connect a new supply line and drain, level the dishwasher and anchor it to the counter or cabinets. Then we run a cycle to check for leaks and proper draining.
Installing a new disposal at the same time? We connect both together. See garbage disposal installation.

What We Install
Standard under-counter dishwashers, aligned and secured flush with cabinets.
Old unit out and hauled away, new unit in and tested.
Water and drain lines run to a new spot during a kitchen remodel.
Learn moreDishwasher water and drain connections for restaurants and cafes.
Learn moreWhat to Expect
Water off, lines disconnected and the old dishwasher removed.
Supply valve checked or replaced; drain loop or air gap set.
New unit connected, leveled and anchored to the counter.
A full test confirms filling, draining and no leaks.
FAQ
Yes. We install customer-supplied dishwashers and bring the supply line and fittings needed for a clean hookup.
Often, yes. We run water and drain lines; an electrician may be needed if there is no outlet or circuit.
Common causes are a loose drain connection, a failing supply line or a worn door seal. We can diagnose it before you replace the unit.
Yes. We disconnect and remove the old dishwasher as part of the installation.
Most standard dishwashers fit a standard opening. We check the height, width and water and drain positions before install.
Most replacements take one to two hours, including removal of the old unit and a test cycle.
A high loop or an air gap is required to keep sink water from flowing back into the dishwasher. We install whichever fits your sink and local code.
Avoid Common Problems
Many dishwasher service calls trace back to the original installation. The most common issue is a drain hose with no high loop or air gap, which lets sink water flow back into the dishwasher and leaves dirty water standing in the tub. Next is a supply line kinked behind the unit, which slows filling and can eventually crack.
Leveling matters more than it seems. A dishwasher that is not level can leak at the door and may not drain completely. A unit that is not anchored to the counter or cabinets can tip forward when the door is opened with a full rack. We check all of this on every install.
Finally, the supply valve under the sink is often decades old. We test it and recommend replacement when it does not close fully, so you can shut off the water quickly if a line ever fails.
If your kitchen water is hard enough to leave spots and film on dishes, a water softener helps the new dishwasher clean better and protects its parts.
Service Area
We install dishwashers from Oceanside to downtown San Diego and up to Temecula.
Call (951) 545-1679 to schedule installation.